Front Floor Panel For Land Rover Defender 90 110 TD4 TDI Aluminum

Description

This aluminum front floor panel replaces the corresponding front floor section on Land Rover Defender 90 and 110 TD4 and TDI. LH and RH versions support a localized floor repair, allowing the affected side to be specified separately from the center floor assembly and rear floor.

Replace the affected front floor section

A front floor panel, center floor assembly and rear floor panel cover different areas. Start with the area identified in the repair, then compare the panel perimeter and attachment positions. If the floor and the supporting body underneath it both need attention, include both in the repair assessment instead of treating a new floor surface as a complete support repair.

Product Details

Plan a front floor repair

• Choose the physical left or right front floor panel for the affected footwell.
• Check the panel against adjoining floor sections before final installation and finishing, using the applicable repair procedure.

Product FAQ

Is this the same part as the center floor assembly?

This is the individual front floor panel in an LH or RH version. The center floor assembly is a separate product; identify which floor section needs replacement before choosing between them.

Does choosing LH mean it is for a left hand drive vehicle?

LH identifies the left side of the vehicle in the direction of travel. It does not state the steering position. Choose the floor side and match the existing layout on your Defender.

Should the floor supports be checked as well?

Yes. Have the repairer assess the floor panel together with its adjoining panels and support areas. Trial-fitting the replacement before permanent installation helps confirm the intended panel position; the repair procedure determines how the surrounding structure is addressed.

Dimensions shown include a 10 cm allowance on each axis. The listed weight is the unpackaged product weight.